About the L5210-DHP-02
L5210-DHP-02
This data gateway module (designated Manufacturer Part Number L5210-DHP-02) is an integrated piece of firmware developed by Eurotherm Solid State Drives. Its design permits the operator to pass information between a DHP network and a LINK network. The information passed between the networks is entirely dependent upon a configuration created and installed using the LINK software tool ConfigEd (Configuration Editor).
The L5210-DHP-02 data gateway consists of a passive backplane that fits into a panel mount accessory, capable of interacting with a switched mode power supply. The switched power supply allows a nominal amount of voltage in the wide range from 80 to 260 volts of alternating current, and has an alternating current fuse for protection, that reaches up to 1 ampere.
Earlier versions of the L5210-DHP module could only be powered by a alternating current power supply with a voltage of up to 115. Earlier versions may be identified by a L5210-DHP-01 manufacturer part number, so make sure to double check if your part needing repair has the “02” identifying suffix. Both versions have three main standard components: the LINK Interface card, the DHP Interface card, and the CPU card. Together, these three cards provide a way to run this data gateway module's firmware successfully.
AX Control offers a well-rounded, comprehensive warranty of up to three years for your purchase. If any products you receive are damaged in transit, or if you’re looking to have inventory of your fixed up or disposed of, our efficient team of technicians are available to take care of any issues.
