About the 0-51418-1
The 0-51418-1 is a small printed circuit board created by Reliance Electric. In some cases, this board may have been sold under other company names like Asea Brown Boveri or Baldor Reliance.
This card has a small grid on the surface. The left side of the grid is labeled A, B, C, D, E, F, G, H, J, K, L, M, N, O, P, Q, R, and S. The upper edge of the grid is labeled in increments of five starting at zero and going five, ten, fifteen, twenty, twenty-five, and thirty. Above the numbered edge of the grid are three metal tabs labeled one, two, and three. These are used to connect wires to the 0-51418-1 board.
In the grid pattern are three long orange wire wound resistors that are connected to the circuit board at either end and also secured using metal brackets in the center of the resistor. To secure this card in place there are two metal brackets at the bottom of the card with holes to place screws.
If you would like to order a 0-51418-1 card or have questions about this card please contact AX Control.
