0-51865-3

About the 0-51865-3

The 0-51865-3 is a CLDD Gate control card produced by the Reliance Electric company. The 0-51865-3 uses a power rack to operate. To control the CLDD card once it is properly installed there is two black dials on the left that are labeled Current Rate and Current Gain. There is a large red Reset button a small red LED indicator labeled IET and four screw ports on the bottom right edge. The 0-51865-3 is a large control card with surface wiring and a couple of capacitors in the very center. However, the 0-51865-3 is a card with a framework around the perimeter and across the top of the circuit board. This framework has small slits spaced equal distance apart on either side. These slits are used to store and use up to twelve smaller circuit boards. These circuit boards are also called daughter boards and slide into place easily. They are held in place using the slits on the framework as well as the metal beam with twelve slits that runs down the center of the circuit board. The metal beam is used to secure the cards when the control card is standing upright in the power rack. Where each card is installed is a series of small pins that are labeled one through ten that are plugged into the smaller cards. For additional information about 0-51865-3 and the types of cards, it can hold please refer to the publications released by Reliance Electric.

To order your 0-51865-3 email or call AX Control.

*Daughter boards are not included with the 0-51865-3 and are sold separately.