0-55300

Product Description

The 0-55300 is a DV/DT printed circuit board that was designed and produced by Reliance Electric to be used within MinPak Plus drives. The 0-55300 DV/DT board continues to be stocked here at AX Control, so be sure to call any time between 8:00 a.m. and 5:00 p.m. during business days. Our friendly, knowledgeable sales representatives will tell you the availability of this product and assist you in placing your order.

The 0-55300 DV/DT board is a rectangular board with just a few different kinds of electrical components placed throughout the board. The most noticeable of these components are the five large cubic or cylindrical capacitors that are placed all around the surface of the board. In addition to that, there are five resistors placed in various locations around the board. Four of these resistors are small in size, but there is one resistor on the shorter end of the board that is much longer, covering almost the entire length of that particular side of the board. On the sides of the board, you will be able to find four metal tabs. Two of these tabs exist on the left side of the board, and these are labeled as “51” and “52.” The other two are located on the opposite side, and these tabs are labeled as “145” and “147.”

When you are ready to begin the installation process of the 0-55300 DV/DT board, be sure to sure the three provided mounting holes. Two are located in the two corners on the left side of the board and one is located toward the right side of the board in the middle.

The 0-55300 DV/DT board weighs about 0.29 lbs. or 0.13 kg.