About the 0-58706-17
0-58706-17 DV/DT MaxPak III Board
The 0-58706-17 is a board component fabricated by Reliance Electric. This circuit board is used within Reliance Electric drive systems, most typically the Max Pak III Drive. The 0-58706-17 is usually marked with the Reliance logo; however, in some situations, the board may originate from ABB or from Baldor Reliance due to changes in the company structure. The number 58706-17 should always appear in the part ID.
The 0-58706-17 is a DV/DT board. The rectangular board has two rectangles excised from its center that make up roughly one-fifth of the board’s overall surface. The board has a grid pattern printed over its surface. The corners have been drilled twice to allow for the mounting of hardware such as standoffs or screws.
The 0-58706-17 has twelve transformers, six per board side. There are twelve thyristors on the board’s surface with wire connections. Wire wound resistors are placed in the bottom left corner of the board. Six more wire wound resistors on standoffs are located at the center top of the board. The board also uses metal film resistors. There are three metal oxide varistors, along with diodes, ceramic capacitors, and six film capacitors. The board has several male and female plug connectors, along with a single vertical male cable connector. This component is lined up with the left edge of the board.
Please consult Reliance publications for more detailed information. Reliance was responsible for providing all technical support, often in the form of publications like manuals and user guides, for the 0-58706-17 and other boards in this series.
