DS200AAHA1 | GE Turbine Control | Mark V |
DS200AAHA1 | GE Turbine Control | Mark V |
DS200AAHA1 | GE Turbine Control | Mark V |
AVAILABILITY:
IN STOCK
SHIPS TODAY
Manufacturer | Reliance Electric |
Series | BRU-200 |
Product Number | DM-20 |
Input Voltage | 100-240 VAC |
Phase | 1 Phase |
Hz | 50/60 Hz |
The DM-20 is a Reliance Electric created 1-Phase BRU-200 series Servo Drive. It was created to go with an Electro-Craft series motor. It could have also been produced by ABB and Baldor Reliance, but it has been since reclassified as a legacy series. It may be a little difficult to find, but AX Control does try to keep it in stock. This product may also be listed under the alternate part number 9101-1302.
The DM-20 is a brushless servo drive that is in control of providing system power and control that is typically needed to run an F-Series or S-Series Electro-Craft Motor. The user has the ability to separately purchase several suggested motors that can be paired with this drive. These motors are F-4030, S-4030, and S-3016. This drive is 120/240 VAC and has a peak amperage of 20A. It also has a continuous amp rating of 10A. This drive has a 141-340 DC bus that has the option of being 325 VDC when using a 230 VAC input. It can handle a command signal range between +/-10 VDCs and 13.3k ohms impedance. It can have a 100W +dissipative shunt max power loss. The normal power loss range is typically around ½ the maximum amount. This device has a 50W continuous shunt and a 4.5 kW peak power shunt. It weighs right around 15lbs.
There are four LED indicators on the faceplate of the DM-20. They are red and green and labeled numerically 1-4. There is a terminal strip that is located on the bottom left side of the faceplate. It has a very small green Ready LED indicator slightly below it. On the right side of the faceplate, there are six other connectors.
Type | Lead Time | Price | Action |
---|---|---|---|
Repair Service | 1-2 weeks | $1424 |
Our highly skilled technicians can repair your DM-20. All of our repairs come with a 3 Year AX Control Warranty. Please contact us for additional information about our repair process. To receive the repair pricing and lead time listed above please process your repair order via our website. The following repair options may be available upon request:
All PLCs, HMIs, and Turbine Control Boards: | 3 Years |
All AC/DC and Servo Drives: | 2 Years |
All Motors: | 1 Year |
AX Control Inc. sells new surplus and reconditioned products. This website is not sanctioned or approved by any manufacturer or tradename listed.
AX Control Inc. is not an authorized distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands appearing
herein are the property of their respective owners.
Copyright 2025 - AX Control Inc. - All Rights Reserved