About the 200FB4042
200FB4042 is a DC Control which is a part of the FlexPak 3000 Series, produced by Reliance Electric. This drive is designed to have a maximum power output of 200 HP. It is regenerative and includes an inverting fault breaker. The required input voltage is 460 volts A-C, with variations not exceeding +15% and -10% nominal. Further information on this drive and its input and output requirements can be found on the drive identification nameplate, in the user manual, and by evaluating the identification number of the drive.
Though this drive comes with the ability to be mounted via chassis, it is also able to be mounted inside of a cabinet. In the event of cabinet mounting, it is up to the user to ensure that temperature and humidity requirements are met. The distributor provides suggested dimensions to have between the cabinet wall and the drive components. These suggestions are 102 mm from either side of the cabinet and 127 mm from the top and the bottom of the cabinet.
When installing a motor, it is important to verify that the motor is rated for the output of the controller. The motor should be installed using the procedure laid out by the manufacturer, ensuring that proper alignment of the armature with any associated mechanisms is achieved. Safety precautions should be taken to ensure that the motor is properly wired and shielded from hazardous or harmful contact. Wiring diagrams for a standard D-C motor can be located in the user manual.
