About the 902FK0501
The 902FK0501 module was created and produced by Rockwell Automation as part of the FlexPak 3000 series of Digital DC Drives. The 902FK0501 module is a Blower Motor Starter Kit that was made to be used alongside FlexPak 3000 and WebPak 3000 Digital DC Drives.
Be advised: Be sure to handle this equipment only if you are qualified and have knowledge of general construction and the operation of this equipment. Any interconnecting wiring should be properly sized and installed in ways that comply with the local, national, and international codes. Without observing these rules, damage to the equipment and injury could be a result.
Included in the 902FK0501 module’s kit, there is a fused three-phase motor starter with an in-line fuses, a wire harness, and an adjustable overload and interlock. The 902FK0501 module has a Blower Motor Starter Full Load Amp Range between 1.7 and 2.4 Amps. The 902FK0501 module’s fuse Amperage is rated at 3.5 Amps. The kit also includes a pre-wired starter assembly on a mounting bracket, two wire ties, and a long wire harness.
Prior to installing the 902FK0501 module, ensure that the kit you are in the process of installing is properly rated for the blower motor that you are connecting. Additionally, ensure that the blower motor you are connecting has a rated voltage that matches the drive’s AC line voltage. Also, do not install modifications while power is applied to the drive. To avoid this, disconnect and then you must lock out the device’s incoming power prior to attempting any sort of installation.
The 902FK0501 module weighs approximately 3.00 lbs. or 1.36 kg.
