14C206

About the 14C206

The Local Operator’s Control Station 14C206 is an additional option for the MinPak Plus Controller. There are features on the control station that allow for further control of the Controller, such as a start/stop function, a torque setting pot, a speed setting pot, a forward/reverse selector, and a run/jog selector. However, the Local Operator’s Control Station 14C206 does not have an automatic/manual selector.

The Operator’s Control Station provides users with extra controls for the Three Phase MinPak Plus. The MinPak Plus Controller is a NEMA Type 12 rating and is complete with an Operator’s Station Faceplate. The default package already comes with the needed equipments to install more modification kits, so there is no need to purchase more equipment.

The 14C206 extension kit has to be installed in the place of the default blank faceplate 14C200. This blank faceplate is located at the bottom left corner of the cabinet door of the MinPak Plus Controller. Clean the area of the rubber circuit breaker boot and remove the blank faceplate, and cut an opening at the top and bottom surface located at the top of the faceplate. The two wire harnesses can then be installed at the cover cut-out. Put the 14C206 Operator’s Control Station in place and make sure it sits properly. Further instructions on how to install the 14C206 Operator’s Control Station can be found in the instruction manual. Do not install or manage the operator's control station without professional knowledge of the equipment.