About the 8030-CC-25
The 8030-CC-25 is one of several power supply cables for the 8030 system available here at AX Control. These cables were originally produced by Schneider Electric.
The 8030-CC-25 cable is 25 inches (64 cm) long and is designed to connect to a P2 connector. This cable should only be used for auxiliary I/O and should not be used for powering a rack with a SY/MAX processor. This cable is capable of a maximum current of 8 amps at 40 degrees Celsius.
The 8030-CC-25 is designed to plug into a P2 connector. When the cable is plugged into the front of a Sy/Max module to one of these connectors, the cable will protrude approximately two inches from the front of the unit.
The 8030-CC-25 must be bent properly to ensure the connectors on the power supplies are not damaged. In order to properly route the 8030-CC-25, the second rack with auxiliary I/O must be placed below the power supply in order to properly route the cables. The 8030-CC-25 should never be bent in an upward direction from the P2 connector. It should be routed downward from the P2.
The 8030-CC-25 includes two slide locks over screws on either side of the connector. Be sure these are both in the open position before beginning any installation.
For more information regarding the proper handling and installation of the 8030-CC-25, please refer to Schneider Electric manuals or user guides.
AX Control typically ships your order within hours of receipt. Let us know if you require expedited service.
